Sport Inboard
Exterior Photos
Sport Inboard
The Sport with a BRP Rotax is a hot rod. It accelerates hard and has a great top end.
Read More
20' 5.3 DI Windshield | |
---|---|
Beam | 94" |
Length Over All | 20' 3" |
Bottom Width | 72" |
Side Height | 28" |
Weight Open | 2,555 lbs |
Weight W/ Windshield | 2,630 lbs |
Fuel Tank | 77 gal |
Side Gauge | 1/8" |
Bottom Gauge | 3/16" |
Dead Rise | 12 degree |
Dead Rise In Bow | 18 degree |
Standard Motor | KEM 5.3 DI V8 |
20' 5.3 DI Center Console V8 | |
---|---|
Beam | 94" |
Length Over All | 20' 3" |
Bottom Width | 72" |
Side Height | 28" |
Weight Open | 2,555 lbs |
Bottom Gauge in Center of Hull | 3/16" |
Weight W/ Windshield | 2,630 lbs |
Fuel Tank | 77 gal |
Side Gauge | 1/8" |
Bottom Gauge | 3/16" |
Dead Rise | 12 degree |
Dead Rise In Bow | 18 degree |
20' 2.3 EcoBoost Windshield | |
---|---|
Beam | 94" |
Length Over All | 20' 3" |
Bottom Width | 72" |
Side Height | 28" |
Weight Open | 2,555 lbs |
Bottom Gauge in Center of Hull | 3/16" |
Weight W/ Windshield | 2,630 lbs |
Fuel Tank | 77 gal |
Side Gauge | 1/8" |
Bottom Gauge | 3/16" |
Dead Rise | 12 degree |
Dead Rise In Bow | 18 degree |
20' 2.3 EcoBoost Center Console | |
---|---|
Beam | 94" |
Length Over All | 20' 3" |
Bottom Width | 72" |
Side Height | 28" |
Weight Open | 2,555 lbs |
Weight W/ Windshield | 2,630 lbs |
Fuel Tank | 77 gal |
Side Gauge | 1/8" |
Bottom Gauge | 3/16" |
Dead Rise | 12 degree |
Dead Rise In Bow | 18 degree |
STANDARD HULL FEATURES
- Limited Lifetime Hull Warranty
- Extended bottom trim plate
- .190″ Transom and bottom
- KEM 5.3 DI V8
- 214 Hamilton jet with turbo impeller
- Diamond plate swim step covering jet on transom
- Aluminum mufflers
- Fresh water-cooling with anti-freeze
- Raw water drains
- Hinged aluminum motor cover
- Built-in, under-floor aluminum fuel tank, baffled
- Secondary fuel feed off tank for kicker fuel
- 1000 MCA battery, box and aluminum holder
- Meets U.S.C.G. standards
- 1/2″ 50 year pressure treated plywood floors covered
w/ marine boat decking - Forward wing for wave deflection
- Full length Welded side trays w/ marine carpet
- Stand-up gunnels with toe kick
- Dual rod storage racks
- Enclosed transom w/ bilge blower
- Transom sink/fish box with cutting board on lid
- UV treated vinyl exterior side color & pin stripe package
- Welded bow and stern eyes
- Welded Sport rails
- Walk-around gunnels w/ non skid
- Storage enclosure under front step deck w/ locking door
- Under floor storage
- Gas/Water separator
- Six panel power source, w/ sealed switches and fuses
- Navigation / Running lights
- 1,250 GPH bilge pump
- Electric horn
- Back lit fuel gauge
- Large two piece “Walk-thru” windshield w/ tempered glass
- Recessed self bailing diamond plate bow deck
- Windshield wiper for drivers side
- All welded dashboard
- Full instrumentation w/ hour meter, tach,
volts, oil pressure & temp - Dash mounted cable steering system
- Two Bentley’s “Sportsman” upholstered seats
- Two all-welded aluminum lockable dry storage boxes
- 12 volt accessories plug in dash
- Dual USB charger in dash
- Transducer bracket w/ welded wire tabs
Many options available
STANDARD HULL FEATURES
- Extended bottom trim plate
- .190″ Transom and bottom
- KEM 5.3 DI V8
- 214 Hamilton jet with turbo impeller
- Diamond plate swim step covering jet on transom
- Aluminum mufflers
- Fresh water cooling with anti-freeze
- Raw water drains
- Hinged aluminum motor cover
- Built-in, under-floor aluminum fuel tank, baffled
- Secondary fuel feed off tank for kicker fuel
- 1000 MCA battery, box and aluminum holder
- Meets U.S.C.G. standards
- 1/2″ 50 year pressure treated plywood floors covered
w/ marine boat decking - Forward wing for wave deflection
- Full length Welded side trays w/ marine carpet
- Stand-up gunnels with toe kick
- Dual rod storage racks
- Enclosed transom w/ bilge blower
- Transom sink/fish box with cutting board on lid
- UV treated vinyl exterior side color & pin stripe package
- Welded bow and stern eyes
- Welded Sport rails
- Walk-around gunnels w/ non skid
- Storage under front step deck
- Under floor storage
- Gas/Water separator
- 6 panel power source, w/ sealed switches and fuses
- Navigation / Running lights
- 1,250 GPH bilge pump
- Electric horn
- Back lit fuel gauge
- Welded center console in front of motor cover
w/ storage and shelf - Console same width as motor cover
- Full instrumentation w/ hour meter, tach,
volts, oil pressure & temp - 12 volt accessory plug on dash
- Dash mounted cable steering system
- Recessed diamond plate step deck
Many options and/or floorplans available
STANDARD HULL FEATURES
Limited Lifetime Hull Warranty
- Extended bottom trim plate
- Center of hull reinforced to .350″ thick by
21″ wide through planing surface - Indmar 2.3 EcoBoost & jet
- Diamond plate swim step covering jet on transom
- Aluminum mufflers
- Fresh water clean out attachment for motor
- Hinged aluminum motor cover
- Built-in, under-floor aluminum fuel tank, baffled
- Secondary fuel feed off tank for kicker fuel
- Meets U.S.C.G. floatation standards on boats under 20′
- Meets U.S.C.G. standards on boats 20′ and over
- 1/2″ 50 year pressure treated plywood floors covered
w/ marine boat decking - Forward wing for wave deflection
- Side panels covered with marine carpet (17′ model only)
- Full length Welded side trays
w/ marine carpet (20′ models and up) - Stand-up gunnels with toe kick
- Dual rod storage racks
- Enclosed transom w/ bilge blower
- UV treated vinyl exterior side color & pin stripe package
- Welded bow and stern eyes
- Welded Sport rails
- Walk-around gunnels w/ non skid
- Storage enclosure under front step deck
w/ locking door on 20′ models - Mercury Gas/Water separator attached to power head
- 6 panel power source, w/ sealed switches and fuses
- Navigation / Running lights
- 1,250 GPH bilge pump
- Mercury tachometer gauge
- Electric horn
- Back lit fuel gauge
- Large two piece “Walk-thru” windshield w/ tempered glass
- Recessed self bailing diamond plate bow deck
- Windshield wiper for drivers side
- All welded dashboard
- Dash mounted cable steering system
- Two Bentley’s “Sportsman” upholstered seats
- Two all-welded aluminum lockable dry storage boxes
Many options available
STANDARD HULL FEATURES
- Limited Lifetime Hull Warranty
- Extended bottom trim plate
- Center of hull reinforced to .350″ thick by
21″ wide through planing surface - Indmar 2.3 EcoBoost & jet
- Diamond plate swim step covering jet on transom
- Aluminum mufflers
- Fresh water clean out attachment for motor
- Hinged aluminum motor cover
- Built-in, under-floor aluminum fuel tank, baffled
- Secondary fuel feed off tank for kicker fuel
- Meets U.S.C.G. floatation standards on boats under 20′
- Meets U.S.C.G. standards on boats 20′ and over
- 1/2″ 50 year pressure treated plywood floors covered
w/ marine boat decking - Forward wing for wave deflection
- Side panels covered with marine carpet (17′ model only)
- Full length Welded side trays
w/ marine carpet (20′ models and up) - Stand-up gunnels with toe kick
- Dual rod storage racks
- Enclosed transom w/ bilge blower
- UV treated vinyl exterior side color & pin stripe package
- Welded bow and stern eyes
- Welded Sport rails
- Walk-around gunnels w/ non skid
- Storage enclosure under front step deck
w/ locking door on 20′ models - Mercury Gas/Water separator attached to power head
- 6 panel power source, w/ sealed switches and fuses
- Navigation / Running lights
- 1,250 GPH bilge pump
- Mercury tachometer gauge
- Electric horn
- Back lit fuel gauge
- Welded center console in front of motor cover
w/ storage and shelf - Dash mounted cable steering system
- Recessed diamond plate step deck
Many options available